mbstarshopcathy

November 23, 2017

09.2017 Xentry Connect C5 Configuration

2017 Xentry Connect C5 user manual: how to configure/set up SDconnect C5 to use for the first time

Please have your XENTRY ConnectMAC addresses (Wi-fi and LAN) enabled for the workshop networkbyyourIT supervisor/IT service provider in advance. You can read off theMAC addresses (Wi-fi and LAN) from the stickers on the devices.

Your case already contains a printed empty network questionnaire.

Please have it filled out by your IT supervisor. Important! Donotcontinuethe initial startup until the questionnaire has been filledoutcompletely! This will help to avoid additional work.

The latest Mercedes diagnostic software 09.2017diskcame with your Xentry Connect C5.

You can start the network configuration now.

Completely charge and turn on the XENTRY Connect.

Starting the XENTRY Connect for the first time can take up to 10 minutes.

Configuration can be started whilst both devices are still charging.

Attention! Be sure to use the correct power supply units!

Start the XENTRY Control software using the desktop link on the laptop. ConfigAssist is already open; ifnot,callup ConfigAssist via the "Configurationâ€ menu.

Note! If you work with static IP addresses, you must performtheconfigurationvia the expert dialog and transfer the configurationtotheXENTRY Connect via a USB stick.

Please have the filled out network questionnaire on hand:

How would you like to configure the devices?

Select one of the 3 options.

Recommended selection: "New without existing configuration dataâ€.

Please continue following the ConfigAssist dialogs and enter the required

data from the network questionnaire.

Next, switch on the XENTRY Connect. This has already finished installing.

In the final steps, the configuration is transferred from the laptop to the XENTRY Connect. You will be prompted tointerconnectthedevices using the supplied black Ethernet connectingcable.

This cable connection is required only for configuration

Ifconfigurationis successful, a green tile with the number of the XENTRYConnect C5willbedisplayed. You can now use the devices: RemovetheblackEthernet connecting cable to work via WLAN and with anonlineconnection. Then click on the green tile in order to read out thedataforordering the StartKey.